Please sign in so that we can notify you about a reply
6/1. Build a better fireworks show with Talon Igniters. Setup is super easy! Just clip the end directly onto the fuse as you would a clothes pin. Compatible with most firing systems.
Installation Tips:
- Do not remove the rubber band. When installing the clip onto the fuse, do not move the clip up, down, or side-to-side on the fuse. Movement after installation can cause damage to the heating element.
- Carefully Install the clip onto the fuse (as if it were a clothes pin going onto a line). The heating element will wrap around and hug the fuse.
- Once installed, tape the clip in place to secure it from movement. This helps protect the element from being damaged prior to operation of the device.
- It is recommended to only connect one safety igniter per cue on the firing system. This allows operator to verify continuity and assures maximum firing current is applied to the device.
- Always use parallel wiring when connecting more than one safety igniter per cue. Never connect safety igniters in series. Test your system to confirm their is enough voltage / amperage when connecting more than one safety igniter per cue. Length of wire will also be a determining factor as to how many safety igniters can be connected in parallel on a single cue.
Store and address
Working hours
Phone
Stock Level
Glencoe
Hardesty
Hooker
Rush Springs
Texhoma
Waukomis
Chickasha
Amarillo
Booker
Canyon
South Dalhart
Alva
Boise City
Cactus
Dumas
Dumas
Intersection of 6100 Stonethrow Dr and Hwy 287 Dumas, TX 79029
5805181520
Available if ordered
Rowena
Slaton
Stratford
Sunray
Liberal